S.King Fulton Shore Power Pedestals

Machined from extruded aluminum, these power pedestals have no seams to crack and are powder coated inside and out. There are three versions of power pedestal available, the Standard, the Slim Line and the Piling Mount pedestal. All models use Stainless Steel hardware with nylon washers and are pre-wired with a power distribution block available in direct (home-run) or loop (daisy chain) feed. Maximum wire size is 500 MCM. The pedestals are rated to 200 Amps per side and available as single-sided or double-sided units.

Warranty:

• 15 years unconditional on structural integrity of the 100% aluminum casing
• 2 years unconditional on construction and fabrication of casing and covers

Slim Line 6"x6"x 36" Wall thickness = 1/8" 4 outlets maximum		Standard Pedestal, 8"x8"x41" Wall thickness = 3/16" 6 outlets maximum
Piling Mount 6"x6"x21" Wall thickness = 1/8" 3 outlets maximum

Receptacles and Circuit Breakers

All S. King Fulton Power Centers use Hubble Marine grade receptacles and are available in:

• 20A Duplex straight-blade GFI
• 20A, 30A and 50A/125V Twist Lock
• 50A/125/250V Twist Lock
• 100A/120/208V Pin and Sleeve single or three phase
• Each receptacle is protected by a SQ-D circuit breaker located on the front of the unit under one powder coated aluminum cover. Lockable covers are available

Receptacle Covers

All receptacles are covered for protection when not in use (receptacles are designed to be water-tight when in use). There are two different types of covers:

• Type "A" - Powder coated aluminum covers that allow the receptacles to be mounted at a 45° down angle (not available on the Piling Mount pedestals).
• Type "T" - Thermo plastic covers where the receptacles are mounted flush with the casing. Manufactured by Hubbell.

Electrical Meters

Available on all power centers and have the ability of metering up to six receptacles individually.

Telephone

Each power center is available with up to four telephone jacks or RJ45 data jacks.

Cable TV

Each power center is available with up to four cable TV jacks.

Lighting

Each power center is available with fluorescent lighting. The light can be wired to an installed photocell or to a separate circuit to allow manual operation. Available with white or amber lens and with or without angled louver to direct lighting downward. Light illuminates three sides.

Hose Bibs

The Standard and Slim-Line models are available with up to two hose bibs using standard 3/4" connections or optional lockable ball valves. The standard hose bib is a 1/4 turn Sillcock.

Water Meters

Up to two internally mounted water meters are available on Standard and Double (not shown) models only.

Hose/Cable Holders

The Standard and Slim Line models are available with up to two hose/cable holders.

Power Distribution Blocks

Each power center comes pre-wired with a power distribution block and is available in direct (home run) or loop (series) feed.

Fully Listed

Meets or exceeds all requirements for UL 231, NFPA 303 and NFPA 70 National Electrical Code Article 555.

Installation

The Standard and Slim Line power centers are designed to be mounted directly to the deck or the dock. A 11/8" gasket for the bottom of the pedestal is supplied. Base templates are available. The Pile Mount unit is designed for mounting on a bulkhead or a pile (specify flat or round brackets).

Configure your pedestal from the options above and call for a quote.

Dockside Lighting and Fire Centers are available in styles to match the above pedestals.